ZETAGI MONZA 2 Z120 10m 11m CB Hame Base Antenna

ZETAGI MONZA 2 Z120 10m 11m CB Hame Base Antenna

  • £89.95
Tax included.


ZETAGI MONZA2 Z120 - brutal 5/8 lambda elemental with over 7m in length and 4 radials in (approximately) lambda 1/4 length - each radial! As this ZETAGI Z120 there are still very few market CB station antennas! In the structure and design, the Z120 reminds to the well-known K46 base antenna. Advance times a few facts about the Z12026-28 MHz8 dB gain (according to manufacturer)Over length: 7m4 Radials - each approx. 7 m long!Loose up to 3000 Watt powerFor mast recording up to 35 mm diameter"Rustic" processes The ZETAGI Z120 antenna is stable. You can see the traditional art of (smaller) series production. This stands out especially compared to antennas, such as the Blizzard, which works almost perfectly styled. It bought manufacturer of Z120 of the antenna "right material". So, for example the individual elements of the spotlight by clamps are kept, but bolted coupling rings! ALU station antenna has seen a CB who is white as robust then as an antenna.The ZETAGI Z120 is designed as to mast antenna for tubes up to 35 mm in diameter. Therefore, the use of optional mast side brackets may be required. We therefore recommend the ZETAGI Z120 rather for users with some experience building with station antennas. The reward:One of the strongest 5/8 lambda CB station antennas on the market - with 4 radials in the lambda 1/4 length!Very good signals in the DX Not only for CB radioThe ZETAGI MONZA2 Z120 can also be very powerful 10m band Mono band amateur radio station antenna come to use. A can be adjusted by changing the radiator length (upper element), specifically up to 28 MHz. NotesA possible small weak point is the connection cable between PL connector and coil, which is somewhat too thin. Here you could E.g. a piece of inside wire - for example by the RG-213 coaxial cable (outer braid remove) take. Technical data / FAQ / product comparison data:Electrical properties of station antennasFrequency range RX and TX26 - 28 MHzProfit according to Hersteller8 dBMax Sendeleistungen3000 Watt PEPRadials4Impedanz50 ohmVSWR (typical) 1, 2:1about bandwidth without Nachstimmen26 - 28 MHzLambda5/8PolarisationVertikalMechanical properties of station antennasLí_nge7, 040 metresLength Radialsca. 270cm - everGewichtca. 5.6 KgAntenneneingangPL JackMastaufnahmeBis approx. 35mmMaterialu.a. aluminum It is a 5/8 Height above the ring of calibration mm. 7,040. For this antenna it has been used material in high-strength aluminum alloy with a thickness of mm. 2.5. The insulation is in the tube of fiber which remains unchanged in time. The calibration can be performed both on the ring (already precalibrated) or acting on the length of the same to change the frequency: - extend for channels below, - shorten for channels above. For installation it is recommended to insert the tube N. 1 diameter 35 directly into a pole as in the figure on the front. Considering the height of the antenna, you must secure it with nylon wires. If you want to extend for the channels below, it is recommended as a rule to remove always the.